Description
Skystars F405 Mini HD2 Flight Controller (20×20 / 6 Uarts / 3-6S)
Introducing the Skystars F4 HD2 Flight Controller, featuring 6 Uarts, a 20×20 mounting pattern, and a 10V 2A pad for DJI Air Units, Vista Kit, or other VTXs. This Flight Controller also has a great layout with easy-to-reach solder pads for your convenience, plus comes equipped with a Barometer for Betaflight and INAV RC Drone FPV Racing.
FEATURES:
- Capability to use M2 and M3 screws using Rubber Grommets included.
- Solder pads are the large and easy to use.
- Proper solder pad spacing to avoid solder bridges.
- ESC connector on top-side rather than bottom which makes it easy for repair.
- TVS Diode for Reverse Polarity Protection and Voltage Spike Suppression.
- Powerful BEC to work with all your electronics.
- Pad arrangement makes sure there is no wires overlapping when you twist the wires of the camera, VTX and RX, for a uniform twist and a clean look.
- DJI connector on the bottom side.
- Two stages of quality checks to reduce any faulty electronics.
- No power lines near Gyro to avoid any EMI interference.
- Ready with I2C and INAV support.
SPECIFICATIONS:
- Input voltage: 3-6S LiPo (11.1V~22.2V)
- MCU: STM32F705RGT6 168MHz
- IMU: MPU6000 (SPI)
- OSD: Betaflight OSD & DJI HD OSD (UART6)
- 6 hardware UARTS (UART123456)
- Receiver: TBS/PPM/SBUS/IBUS/DSM
- Barometer: No
- Buzzer Pad: Yes
- CURR Pad: Yes
- BEC: 5V 2A & 10V 2A (Max 3A)
- Blackbox: 16MB
- Firmware: Betaflight / INAV SKYSTARS F405HD
- Mounting Holes: 20 x 20mm / M3 or M2
- Weight: 0.16oz (4.8g)
INCLUDES:
(1) Skystars F405 Mini HD2 Flight Controller
(5) M2/M3 Rubber Dampeners (Orange)
(4) Rubber Dampeners (Red)
(1) 8-Pin ESC to FC Cable
NOTES:
- Manufacturer upgrades, alterations, and processor/firmware changes frequently made without prior notice. Exact specifications, photos and links cannot be guaranteed.
